Stack on safe manual
Looking for:
Stack on safe manual |
Stack on safe manual
Storing your Key or Combination will provide instant access to this important information should you ever lose your keys or your combination. Only you will have access to this information. Record the serial number from the tag on the back of the safe or from the tag on the front bottom corner of the safe. Record the key and your combination numbers. Failure to secure the safe as shown in these instructions can result in death or serious injury to children and adults. Keep keys and combination in a secure place away from children.
Do not move this safe using its handle. The handle should only be used for opening and closing the door of the safe. For greater security the safe must be fastened to a solid surface with a minimum space on either side. See figure 2 Ideally, full sized safes would be installed in the corner of a closet. Secure the safe to the wall or floor using the holes and hardware provided. See figure 3 Note: For the holes in the back of the safe, drill a clearance hole through the liner board before installing the mounting hardware.
These numbers are preset. You should change the entry code as soon as possible after opening the safe to insure proper security. After you have entered the factory code, you will need to turn the handle clockwise to open the door.
You will have 5 seconds to turn the handle before the locking mechanism is reactivated. After opening the electronic safe with the preset factory code of 1, 5, 9, locate the small red red button on the inside of the door near the hinge. Press the red button and then release it, you will hear a beep. The yellow light on the faceplate will be activated and will stay on for a period of time that should allow you to enter your code.
You can only enter your code while the yellow light is on. With the door open and the yellow light on, enter your own personal security code, which can be 3 - 8 digits long, and confirm your new code by pressing the " " symbol on the electronic touch pad. Before you close the door, try the new security code to make sure the lock releases the handle so you can turn it and retract the live action bolts.
If the code fails, go through steps 1 and 2 again. If the code works successfully record your combination number on the front of this form or somewhere in your records, then you should lock the safe.
When you open the safe in the future enter the security code you have set followed by the " " symbol. If the incorrect security code is entered 3 times you will have an automatic lockout for 20 seconds before you can try your code again. If the incorrect security code is entered 3 additional times there will be a 5-minute lockout before the code can be tried again.
You can turn off the "Beep" sound of the keypad by entering the code To turn the "Beep" sound on, enter the code NOTE: When changing the battery, always hold the battery connecting cap while disconnecting or attaching the battery.
Do not pull on the wires. Doing this could cause the power supply to become disconnected from the lock. This safe uses one 9V alkaline battery. Under normal use, batteries will last about 1 year. When the battery is low and you press a button on the keypad, a red light will come on warning you that the battery is low. To test the batteries, enter your security code. If the batteries are low the red light will come on momentarily. To replace the battery, remove the cover by pressing the tab and turning the cover as shown in the illustration.
Replace the old battery and screw the cover back in place. A "Trouble Key" has been provided in case you have forgotten or lost your security code. To open the safe using the trouble key follow the steps below:. Remove the cover by pressing the tab and turning the cover as shown in the illustration.
The lock can hang by the connecting cable while unlocking the safe. Rotate the handle and open the door. Keep the door open until you have entered a new security code. Before entering your new code, remove the key and screw the cover back in place.
Enter your new security code following the instructions at the top of the page. Keep keys and combination number in a secure place, away from children. Keep this record of your key number and combination in a secure place separate from your safe.
To order a replacement key set, follow the instructions on the attached form. Storing your Key or Combination will provide instant your keys or your combination. Verification of ownership is required in order to receive replacement key for your security product. In order to receive a replacement key to your security produc t:. Complete the following form and send to Stack-On Products. Send a copy of the receipt showing the original purchase. Security product owner must sign form.
Personal Check, MasterCard, or Visa accepted. Send completed information to:. Stack-On Products Co. This warranty extends to the initial consumer only. If you believe there is a defect in material or workmanship in your Steel Safe during the three-year warranty period, please contact our customer service department, by regular mail or email at the address listed below, and include with your correspondence proof of purchase information and the model number of the safe.
If Stack-On is properly notified during the three-year warranty period and, after inspection confirms there is a defect, Stack-On will, at its sole option, provide repair parts or exchange the product at no charge, or refund the purchase price of the product. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox.
Please check your email for further instructions. Enter a new password. Security Safes Electronic Lock. Children should not play with or around the safe at any time. Do not store spare key or this document in the safe. The safe should be flat against the wall and floor. See figure 3 Remove the baseboard if necessary.
Mark the holes to be used. Drill the appropriate diameter and depth of pilot holes depending on the type of hardware being used and the type of mounting surface.
Secure the safe with the fasteners. The top tray of the door organizer, which is included on select models, can be adjused by removing the two screws and relocating the tray. SS-E 1 To open the safe using the trouble key follow the steps below: 1. In order to receive a replacement key to your security produc t: 1. Old Rand Road P. You can only view or download manuals with. Sign Up and get 5 for free. Upload your files to the site.
You get 1 for each file you add. Get 1 for every time someone downloads your manual. Buy as many as you need. View and download manuals available only for. Register and get 5 for free. Upload manuals that we do not have and get 1 for each file. Get 1 for every download of your manual. Buy as much as you need. Screw the scope stand-off into the pilot hole. For best results this safe should be installed in an isolated, dry and.
See figure 3. Drill the appropriate diameter. The shelving can be installed by locating the shelf clips. The top tray of the door organizer, which is included on.
- Stack on safe manual
Storing your Key or Stack on safe manual will provide instant access to this important information should you ever lose your keys or your wafe. Only you will have access to this information.
Do not store trouble key or this document in the safe. The handle should only be used for opening and closing the door of the safe. Children could accidentally be locked inside the safe. Stack on safe manual material will not survive the rated internal temperature of the safe.
Screw the 5 handle spokes into the hub and hand tighten. These spokes are located in the front foam staco. These numbers are preset. You should change the entry code as soon as possible after opening the safe to insure proper security.
After you have entered the factory code, you will need to turn the handle clockwise to open the door. You will have 5 seconds to turn the handle before the locking mechanism is reactivated. Your safe should be installed in an isolated, dry and secure area. For zafe humidity control we recommend manuwl use of a desiccant.
Do not drill holes in the safe eclinicalworks v11 user manual pdf electrical dehumidifying devices. Do not drill through the insulation in the rear vent holes. Do not mount the safe адрес страницы a wall using these vent hole.
This will void the stack on safe manual rating. For greater security the safe should be located in a corner and fastened to the floor. As the water level rises, the safe will begin to float and could fall over causing personal injury. The safe must be fastened to the floor using the lag bolts and gasket washer provided with this safe to insure the waterproof rating.
Failure to do so will void the waterprooof rating. Stack on safe manual must remove the safe from the skid and place the safe on the floor. Failure to do so will void the fire and waterproof ratings. Place the safe in the desired location. Lift the carpeting up and locate the mounting hole bushings. These bushings are filled with fire resistant caulking which must be drilled out before mounting the safe to the floor.
Continue to use this msnual to mark the hole location on the floor. Move the safe away. Failure to do so will void the fire rating and waterproof rating. Reposition the safe and secure the safe with the lag bolts and gasket washers. Replace the carpeting. After opening the electronic safe with the preset factory code of 1, 5, 9, locate the small red red button on the inside of the door near the hinge.
Press the red button and then release it, you will hear a beep. The yellow light on the faceplate will be activated and will stay on for a stack on safe manual of time that should allow you to enter your code. You can only enter your code while the yellow light is on. With the oon open and the yellow light on, enter your own personal security code, which can be 3 - 8 digits long, and confirm your new code by pressing the " " symbol on the electronic touch pad.
Before you close the door, try the new security code to make sure the lock releases the handle so you can turn it and retract the live action bolts. If the code fails, go through steps 1 and 2 again.
If the code works successfully record your combination number on the front of this form or somewhere in your records, then you should lock the safe. When you open the safe in the future enter the security code you have set followed by the " " oon. If the incorrect security code is entered 3 times you will have an automatic lockout for 20 seconds before stack on safe manual can try your code again.
If the incorrect security code is entered 3 additional times there will be a 5-minute lockout before the stwck can be tried again. You can stack on safe manual off the "Beep" sound of the keypad by entering the code To turn the "Beep" sound on, enter the code NOTE: No changing the battery, always hold the battery connecting cap while disconnecting or attaching the battery.
Do not pull on the wires. Doing this could cause the power supply to become disconnected from the lock. This safe uses one 9V alkaline battery. Under normal use, batteries will last about 1 year. When the battery is low and you press присоединяюсь sample accounting manual free download правы button on the keypad, a red light will come on warning you that the battery is low.
To test the batteries, enter your security code. If the batteries are low the stack on safe manual light will come on momentarily. To replace the battery, remove the cover by pressing mwnual tab and turning the cover as shown in the illustration.
Replace stack on safe manual old battery and screw the cover back in place. A "Trouble Key" has been provided in case you have forgotten stack on safe manual lost your security code. To open the safe using the trouble key follow the steps below:.
Remove the cover by pressing the tab and turning the cover as shown in the illustration. The lock can stack on safe manual by the connecting cable while unlocking the safe. Keep the door open until you have entered a new security code. Before entering your new code, remove the key and screw the cover back in place.
Enter your new security code following the instructions for entering your security code. NOTE: The scope stand-off will function properly for many combinations of guns with scopes. The shelving can be installed by locating the shelf clips to the desired locations and setting the shelf in place. Keep keys and combination number in a secure place, away from children. Keep this record of your key number and combination in stack on safe manual secure place separate from your safe.
To order a replacement key set, follow the instructions on the attached form. Storing mamual Key or Combination will provide instant your keys or your combination. Verification of ownership is required in order to receive replacement key for your security product.
In order stack on safe manual receive a replacement stack on safe manual to wafe security produc t:. Complete the following form and send to Stack-On Products. Send a copy of the receipt showing the original purchase. Security product owner stack on safe manual sign form. Personal Check, MasterCard, or Visa accepted.
Send completed information to:. If Stack-On chooses to repair the safe, such repair work may be performed by a local technician approved by Stack-On. Depending on the extent of the damage, Stack-On may require the safe be returned to the factory for repair. If the safe is so returned, Stack-On will pay stack on safe manual freight to the factory as well as the return freight.
If the safe is replaced, Stack-On will pay the freight. This guarantee does not cover labor costs for removal or installation of the safe stack on safe manual its contents. Any repair, dismantling, or tampering undertaken without the prior written approval or direction of Stack-On will nullify this guarantee. Personal property in the safe is not covered under this guarantee. Stack on safe manual warranty extends to the initial consumer only.
If Stack-On is properly notified during the 5-year warranty period and, after inspection confirms there is a defect, Stack-On will, at its sole option, provide repair parts or exchange the product at no charge, or refund the purchase price of the product. Please send your claim pursuant to the above guarantee or warranty жмите сюда writing by regular mail or email to:.
Xtack under this limited reimbursement guarantee is limited exclusively to direct physical loss caused by a flood in which the water stack on safe manual does not exceed 24 inches for a period of 72 hours; it does not include stack on safe manual damage that might occur manjal conjunction with a fire. Reimbursement will not be provided for any consequential or incidental damages. Finally, this limited reimbursement guarantee is null and void if the safe is improperly installed or if the safe is left open at any point during the flood.
Please send requests Так apa publication manual 6th edition download оно content reimbursement in writing to: Stack-On Products Company. This limited reimbursement guarantee does not include the replacement of the safe due to a flood or water damage. Welcome to ManualMachine. We have sent a verification link to to complete your registration.
Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Manual q60 Defense Electronic Lock. Failure to secure the safe as shown in these instructions can result in death or serious injury to children and adults.
Comments
Post a Comment